rc connectors*rc plug*RC FPV Cable|RC Connector*RC Connectors,FPV Cable,GoPro HD FPV Cable,Servo Wire
Categories
  • UBEC¡¢Navigation Light...
  • Safe ParaBoard
  • Tools
  • Connector
  • Cable * Other materials
  • RC Switch & Battery Box
  • Coax Cables & Antennas
  • Adaptor
  • Radio Controlled Micro connec...
  • Battery Lead
  • Charger Leads
  • = Conversion Connector
  • Extension Wire
  • + Parallel Wires
  • * Serial Harness
  • 1 to X Wire
  • Light Cable
  • Extension Wire

    • SAFE ParaBoard

      Power ParaBoard is designed and developed by Power ParaBoard, This device is to be used with a balance charger tosimultaneously charge multiple lithium batteries in parallel. By this method you can significantly save time on battery charge process. Parallel charge can save your time significantly. If you charge

    • 5730 Navigation Light

      Dimension : 45mmWeight : 7.9gVoltage : 12VMaterial : AluminumColor : White/ Red/Green / Yellow /BlueProducts for :Multi-Rotor /Helicopter/Aircraft / Car

    • LED System For R/C Car

      Hits£º3 Voltage Range : 5v-6vSize:35.5mm*31.5mm*9.5mm (L*W*H) Weight:7.8g (for the LED System Control Board)Light Cable:28AWG Silicone WireHow to install:1. Confirm the size and installation position of LED lights, then marked.2.Drill some LED holes

    • 6A UBEC

      Designed with an advanced switch mode DC-DC regulator IC, the max efficiency of the chip is up to 93%; The small size and the light weight make it very convenient to use; The output current is very large, the continuous outp

    • Navigation Lights(RC Mode/Standalone)

      1.LED : 1W2.Voltage : 4-6V3.Current Consumption : 20mA4.Wire : 45cm 26AWG5.Color(selection) : White¡¢ Red¡¢ Blue¡¢ Green¡¢ Orange6.Flash : 67.working modes: RC ModeManufactured : KNT

    • KNT UBEC

      KNT 5A UBEC is a switch-mode DC-DC regulator supplied with a 2-6 cells lithium battery pack (or 5-24 cells NiMh /NiCd battery ) and it outputs a consistent safe voltage for your receiver, gyro and servos. It is very suitable for RC helicopter.

    • Distribution Board

      Distribution Board V1.0 (10cm 14AWG silicone wire(0.08) + Male T Plug + PE Heat shirink tubing)

    • Firefly LED

      LED strips for easy mount on RC Cars. Extremely bright LEDs which gives the coolest light and has low power consumption. Firefly LED Strips are easy installed with 3M tape on your RC Car body or chassis. The LED strips connects directly to your receiver. Choose color above. Firefly LED Strips specifications:-2 x LED S

    • ParaBoard

      3S Charging ProtectorT Plug , XT60 Plug , TRX Plug , 3.5mm EC3 Plug , 5.0mm EC5 Plug , 3.5mm Red Shell Plug , 4.0 mm Red Shell Plug

    • Wireless Voltage Display

      1, Real-time return 2S \ 3S battery of circuit voltage and total voltage.2, Could set the alarm voltage,the range: 3.3V-4.2V, other ranges please state in advance.3.Real-time return the vertical height distance from the take-off point.4 Real-time return the temperature of aircraft cabin .5, Records the the maximum of u

    • rc solder jig (KT-1801-II)

      KT-1801-II is very suitable and helpful for DIY players to welding. Its arm can be up and down 180 ¡ã and rotate swing 360 ¡ã. It can solve a series of problems caused by welding overheating , whether the products are round or square , it can be easy to grip.KT-1801-II is used in Banana Jack, Deans Plug, Mini Deans Plug,

    • rc soldering jig (KT-1802B)

      http://v.youku.com/v_show/id_XMzcyMDUzMDI0.html'KNT JIGS' - Soldering Jig for RC Connectors(RC TOOL) It is the best helper for below products: Banana Jack: 0.8 to 10.0 mm malefemale gold connector, also the gold connector with angle. (Suitable for all the sizes of the gold connectors) Plug: Deans Plug, MINI Deans

    • KNT RC JIG

      'KNT JIGS' - Soldering Jig for RC Connectors(RC TOOL) It is the best helper for below products: Banana Jack: 0.8 to 10.0 mm malefemale gold connector, also the gold connector with angle. (Suitable for all the sizes of the gold connectors) RC Plug: Deans Plug, MINI Deans Plug, MPX Plug, Tr